How To – Mud Knots

I thought I would put up a How To today on tying up tails for the winter. I’ve done this most years here in wet, western Oregon. Vinnie’s tail had started to get clods of adobe permanently building up on the end of his tail. They can become heavy, get caught on branches and even pull out large sections of tail. Vinnie’s tail already touches the ground. Add a few inches of mud to sink into and I’ve got a problem… I’ve found this to be an excellent solution.

Start with a relatively clean tail. I washed, combed and conditioned both Lily & Vinnie’s tails, thanks to abundant free samples of Eqyss Premier Cream Rinse Conditioner from my local feed store. I’ve liked all the products from this company that I have used so far. I’ll see how their tails look when I take them down in a few weeks. Vinnie was my model today, since his tail is so nicely multi-colored.


You will need a strip of fabric. I use the end of a turban, handy for me, but likely not for the average horse owner. Any lightweight cotton fabric will do. Mine was about 50″ long and maybe 3″ wide. Locate the end of the tail bone and section the tail into three parts. Take the middle of the fabric strip and run it behind the tail with each side running along two braiding sections.


Braid the tail, holding it down toward the horse’s hocks and the ground, incorporating the fabric into the braid. If you don’t hold the tail downwards, your braid will not hang nicely or will have a bulge on the underside. I leave about 10″-12″ of unbraided tail. This will be left open when the mud knot is finished. Wrap the fabric once around and tie. You should have about 6″ or more fabric left for the next step.

If you don’t want any loose hair, you can braid to the end of the tail. You will either need a longer piece of fabric or braid half way before adding the fabric in. Either way you need some fabric left at the end.


Open a space in the braid at the top, just under the end of the tail bone.


Thread the end of the braid through this space from the underside.


Run one fabric end through the space and wrap them around the tail, so that they can be tied into a square knot. Be sure to stay below the end of the tail bone. We don’t want to damage any of the living part of the tail by putting pressure on it.


Lay the open, brush end of the tail flat against the front of the, now folded, braid. This is a side view of the bundle just before wrapping in vetwrap. I cover the entire braided portion, making a point of not covering the loose end or the tail bone.

If I were going to wrap the entire tail, I would make the bundle longer, just folding the braided end of the tail up. It would then get covered in vetwrap.


The end result – a much shortened tail that will stay clean and protected from the mud!

Unless my work falls apart, I plan to leave their tails up for 3-4 weeks. I’ll take them down, check them and likely put them back up. It will be interesting to see how long they grow over the winter. I may need to do some trimming come springtime.

For more photos of them enjoying the nice grass, visit my Flickr page. It was a really lovely day and they enjoyed some time in a new paddock. Their paddock was getting gravel added around the gate.